08-14-09, 11:30 PM | #1 |
BassFishin.Com Active Member
Join Date: Jul 2008
Location: Southeastern/Ky
Posts: 155
|
Water pressure guage help
Ok, this might be a dumb question but here goes. Where does the tube from the guage go on a 1984 Johnson Gt 150? It had a water pressure guage in the other boat this motor was on but like everything else on it, it wasn't working. I thought that it would T off of the pisser line out of the head on the starboard side. But that can't be right because it doesn't have a T in that line on the motor. So back to the question at hand, Where do I hook the tube from the guage on the motor?
Any info. would be nice. Thanks guys.......DJ |
08-15-09, 01:14 AM | #2 |
BassFishin.Com Super Veteran
Join Date: Feb 2006
Location: Parkesburg, Pa.
Posts: 3,762
|
Most outboards have a bypass tube (black, 3/8" or 1/2" tubing) on the top of the block. I haven't seen a Johnson or an outboard that old, so you may have to look for it. Should be on top and if the tee isn't there already, you'll have to cut one in to connect the tubing to the gauge. Don't cut it into the pisser line, you won't have any pressure.
|
08-15-09, 10:52 PM | #3 |
BassFishin.Com Active Member
Join Date: Jul 2008
Location: Southeastern/Ky
Posts: 155
|
I haven't seen a T in any water lines on the motor at all. It makes no sense to me at all. This motor had a water pressure guage on the boat that it came off of but for the life of me I can't find where it was connected at the motor.
DJ |
Disclosure / Disclaimer
Before acting on the content posted, you should know that BassFishin.Com may benefit financially and otherwise from content, advertising, links or otherwise from anything you click on, read, or look at on our website. Click here to read our Disclosure Policy and Disclaimer. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | Rate This Thread |
|
|