12-19-07, 04:20 PM
|
#11 |
|
BassFishin.Com Super Veteran
Join Date: May 2006
Location: Accokeek MD
Posts: 3,315
|
To test it, it is simple. Remove single wire from trim sensor located under pivot pinion of motor. Turn key on to run. Ground wire and watch gauge jump. If gauge not moving check ground is good and clean repeat. If still not moving Place OHM meter on ground and single wire of sensor. Tilt up and see if resistance changes.
I have replaced about four in my life and everyone was corroded internally. Never the gauge yet. Capt Mike
__________________
Capt Mike Starrett light tackle guide Potomac River http://www.indianheadcharters.com |
|
|
|
Disclosure / Disclaimer
Before acting on the content posted, you should know that BassFishin.Com may benefit financially and otherwise from content, advertising, links or otherwise from anything you click on, read, or look at on our website. Click here to read our Disclosure Policy and Disclaimer. |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode